Nowadays, more and more families choose to use Membrane structure parking shed Do you know what problems should be paid attention to when manufacturing the membrane structure parking shed? The following is a detailed introduction:

   The sealing plate is located on the top of the membrane structure parking shed. The quality shall be selected from the wind resistance and corrosion resistance. The color can be selected at will. It is appropriate to select good shading effect as far as possible.

   The keel frame shall be made of square steel welded keel frame. This shelf is practical and can effectively resist wind and impact. For long-term use, we can also spray anti-corrosion paint on the outside. In this way, the overall effect is very good. Durable.

   For internal use of membrane structure parking shed Φ The galvanized round pipe welded to the shed frame can not only effectively enhance the top strength, but also make the shed ventilated and have a good lighting effect. It also meets the national parking shed construction requirements.

   The column base of membrane structure parking shed must be used 10mm thick steel plate and embedded parts are firmly welded, and embedded parts need to be cast with concrete and fixed with bolts, so as to improve the overall firmness again.

These are the four problems that need attention when manufacturing the membrane structure parking shed. If you choose this kind of shed, you must pay attention to the above items to ensure the quality. The use of membrane structure parking shed will also cause rust, so rust prevention treatment shall be carried out regularly. Sand blasting and shot blasting. This antirust treatment method mainly uses a sandblasting machine to remove rust spots on the steel surface, and then restore the original color of the metal. The special advantage of this processing method is that the processing effect is more complete and the work efficiency is higher. So far, this is a more advanced derusting method. In addition, the relatively advanced sandblasting machine technology also has good environmental protection performance. It can effectively avoid some air dust and powder problems caused by construction during rust removal.

   Manually remove rust. Manual derusting is usually only suitable for processing some smaller light steel and angle steel, but manual derusting will not only lead to incomplete derusting effect, but also low efficiency. Therefore, the operator must be careful and patient during this work.

   Pickling and phosphating. This treatment is usually to pickle the rusty ingredients on the surface, and then use 2% phosphoric acid for one-step phosphating treatment. The surface of the parts thus treated will produce phosphating film. It not only plays the role of rust removal, but also can effectively prevent embroidery of parts, and can also increase the adhesion of paint on its surface and enhance its corrosion resistance. The rust removal method using this process is relatively simple.

   Pickling and derusting. Pickling and derusting are processes of removing rust from pickling tanks. Components taken out of the pickling tank usually show gray luster on the surface, so it is necessary to add cleaning steps. In order to prevent embroidery, you can also apply a layer of anti rust oil on the surface of the components.

The content of this article comes from the network. If you have any questions, please contact me to delete it!