one Membrane structure glass canopy The specifications and standards of steel beams shall be in accordance with the drawings. Rust removal shall be carried out before construction, and then anti rust paint shall be sprayed twice, and white finish paint shall be sprayed three times.
2. When the embedded parts are started, they must be executed according to the drawings. Installation treatment: locate the installation position of embedded parts in advance and start drilling installation. The position of embedded parts shall be accurate, the elevation deviation of embedded parts shall not be more than 9mm, and the displacement shall not be more than 20mm.
3. Connecting stressed cable of membrane structure glass canopy: the datum line and elevation line of positioning rod must be installed with embedded parts and welded railings according to its requirements.
![membrane structure membrane structure](/data/upload/image/20200531/1590912742274373.jpg)
4. Installation and welding of stainless steel glass claw: snap up the vertical and horizontal lines and design elevation according to the design size, clamp with clamps, spot weld, and weld the glass claw seat after assembly.
![Membrane structure glass canopy Membrane structure glass canopy](/data/upload/image/20200531/1590912780808430.jpg)
5.12mm thick glass is tempered glass.
6. Gluing up and down: fully clean the glass gap without water, oil, paint, rust, cement mortar, dust, etc., and fully clean and dry the joint surface. In order to adjust the seam depth, avoid three side glue. Paste protective tape on both sides of the joint to prevent the glass from being polluted. At the same time, apply sealant up and down. After injecting sealant, smooth the surface of sealant joint with a trowel to remove excess glue. After glue injection, tear off the protective paper and wipe the glass with solvent if necessary. Do not touch dust and scratches until the glue has completely hardened.
The content of this article comes from the network. If you have any questions, please contact me to delete it!